Bismuth recovery from acidic solutions using Cyphos IL-101 immobilized in a composite biopolymer matrix

Overview & Synopsis

Impregnated resins prepared by the immobilization of an ionic liquid (IL, Cyphos IL-101, tetradecyl(trihexyl)phosphonium chloride) into a composite biopolymer matrix (made of gelatin and alginate) have been tested for recovery of Bi(III) from acidic solutions. The concentration of HCl slightly influenced Bi(III) sorption capacity. Bismuth(III) sorption capacity increased with IL content in the resin but non-linearly. Maximum sorption capacity reached 110–130 mg Bi g−1 in 1 M HCl solutions. The mechanism involved in Bi recovery was probably an ion exchange mechanism, though it was not possible to establish the stoichiometric exchange ratio between BiCl4− and IL. Sorption kinetics were investigated through the evaluation of a series of parameters: metal concentration, sorbent dosage, type and size of sorbent particles and agitation speed. In order to reinforce the stability of the resin particles, the IL-encapsulated gels were dried; this may cause a reduction in the porosity of the resin particle and then diffusion limitations. The intraparticle diffusion coefficients were evaluated using the Crank's equation. Additionally, the pseudo-first-order and pseudo-second-order equations were systematically tested on sorption kinetics. Metal can be desorbed from loaded resins using either citric acid or KI/HCl solutions. The sorbent could be recycled for at least three sorption/desorption cycles.