Parameterizing Haverkamp Model From the Steady‐State of Numerically Generated Infiltration: Influence of Algorithms for Steady‐State Selection

Overview & Synopsis

BEST (Beerkan Estimation of Soil Transfer parameters) methods of soil hydraulic characterisation are widely applied for estimating sorptivity, S , and saturated hydraulic conductivity, K s . Calculating these properties requires choosing the β and γ parameters of the Haverkamp infiltration model. These parameters can be obtained from numerically simulated three‐dimensional (3D) infiltration runs reaching steady‐state. This investigation tested dependence of the estimated β and γ parameters on the algorithm for steady‐state selection using simulated 3D cumulative infiltrations for different soils and initial conditions. Two algorithms used the original simulation outputs and included using (i) a threshold defining steadiness (T‐algorithm) and (ii) the last four data points, yielding a reference value of steady‐state infiltration rate (R‐algorithm). A third algorithm, similar to the R‐algorithm, was applied to previously re‐sampled infiltration data at fixed time intervals (RR‐algorithm). The intercept, b s , of the straight line fitted to the data describing steady‐state on the cumulative infiltration plot depended on the applied algorithm more than the slope of this line. Consequently, β varied with the applied algorithm more than γ . The RR‐algorithm, yielding 0.62 ≤ β ≤ 1.99 and 0.74 ≤ γ ≤ 0.98, was preferred since it mediated between advantages and disadvantages of T‐ and R‐algorithms. The influence of the choice of proper values for β and γ on the estimates of S and K s was evaluated using BEST. Using the default values of β (0.6) and γ (0.75) yielded accurate estimates of S but not of K s . Soil dependent β and γ values should be used in this case. A check of the reliability of the estimates of b s can be made by a sequential analysis of the cumulative infiltration data. Future developments include considering sources differing in size and establishing if the suggested β and γ values apply in general to the available BEST algorithms.