Reset
Showing 20 of 75 academic articles

Light Absorption and Emission by Defects in Doped Nickel Oxide

Robert Karsthof, Ymir Kalmann Frodason, Augustinas Galeckas, Philip Michael Weiser et al. • Advanced Photonics Research (2022)

Nickel oxide is a versatile p‐type semiconducting oxide with many applications in optoelectronic devices, but high doping concentrations are often required to achieve necessary electrical conductivity. In contrast to many other transparent ...

DOAJ Open Access (DOAJ) DOI: 10.1002/adpr.202200138

High-Energy Neutrino Astrophysics

J. G. Learned, Karl Mannheim M • Annual Review of Nuclear and Particle Science (2000)

▪ Abstract High-energy (>100 MeV) neutrino astrophysics enters an era of opportunity and discovery as the sensitivity of detectors approaches astrophysically relevant flux levels. We review the major challenges for this emerging field, amon...

OPENALEX DOI: https://doi.org/10.1146/annurev.nucl.50.1.679

Numerical investigation of corroded middle‐high strength pipeline subjected to combined internal pressure and axial compressive loading

Linlin Lu, Lecai Liang • Energy Science & Engineering (2021)

Abstract Buried oil and gas pipelines may face the threat of geological disasters such as landslides, faults, and floods. However, long‐term buried oil and gas pipelines often have corrosion defects, which bring greater challenges to the sa...

DOAJ Open Access (DOAJ) DOI: 10.1002/ese3.830

Accuracy Analysis of Convergence Monitoring in Twin-tube Shield Tunnels Using Mobile Laser Scanning

WANG Xinhong, XIA Caichu, HU Guojin, WU Ting et al. • Chengshi guidao jiaotong yanjiu (2025)

[Objective] Mobile 3D laser scanning technology is widely applied in single-tube tunnel monitoring due to its excellent measurement efficiency and high accuracy. However, the application of this technology for deformation monitoring in twin...

DOAJ Open Access (DOAJ) DOI: 10.16037/j.1007-869x.20230782

POSSIBILITIES OF REGENERATION OF THE MUSCLES OF THE SOFT PALATE DURING ITS NONUNION DEPENDING ON THE MYOGENIC POTENTIAL OF STEM CELLS. Review

L.V. Kharkov, R.I. Egorov • Медична наука України (2020)

Relevance. Today there are more than 150 methods for eliminating congenital defects of the hard and soft palate. However, these techniques do not always lead to high functional results, which leads to repeated surgical interventions and lon...

DOAJ Open Access (DOAJ) DOI: 10.32345/2664-4738.3.2020.10

<i>Vegfr3</i> and <i>Tbx1</i> Interact in Cardiac Morphogenesis

Stefania Martucciello, Marchesa Bilio, Sara Cioffi, Ilaria Aurigemma et al. • Journal of Cardiovascular Development and Disease (2026)

Gene inactivation in model organisms has identified numerous genes and signaling pathways involved in mammalian cardiac outflow tract (OFT) development. Human genetics data have implicated the VEGFR3 gene in OFT development, but when and wh...

DOAJ Open Access (DOAJ) DOI: 10.3390/jcdd13080399

RNA-seq analysis of gene expression profiles in isolated stria vascularis from wild-type and Alport mice reveals key pathways underling Alport strial pathogenesis.

Brianna Dufek, Daniel T Meehan, Duane Delimont, Kevin Wilhelm et al. • PLoS ONE (2020)

Previous work demonstrates that the hearing loss in Alport mice is caused by defects in the stria vascularis. As the animals age, progressive thickening of strial capillary basement membranes (SCBMs) occurs associated with elevated levels o...

DOAJ Open Access (DOAJ) DOI: 10.1371/journal.pone.0237907

Investigation of Defect Effects on Adhesively Bonded Joint Strength Using Cohesive Zone Modeling

Majid Jamal-Omidi, Mohammad Reza Mohammadi Suki • Journal of Mechanical Engineering (2018)

In this paper, effects of the defect in an adhesively bonded joint have been investigated using cohesive zone modeling. Consequently, a 3D finite element model of a single lap-joint is constructed and validated with experiments. Strength pr...

DOAJ Open Access (DOAJ) DOI: 10.2478/scjme-2018-0023

On-board diagnostics method for detecting bearing defects in traction synchronous permanent magnet motors based on stator current spectrum

E. A. Dvoeglazov, O. A. Kozelkov, P. K. Dyakov • Вестник СибАДИ (2026)

Introduction. The reliability of traction electric drive is a key factor determining the operational efficiency of urban electric transport. Bearing assemblies of electric motors remain one of the most common causes of failures leading to v...

DOAJ Open Access (DOAJ) DOI: 10.26518/2071-7296-2026-23-2-334-348

Automatic visual inspection system for quality control of the sandwich panel and detecting the dipping and buckling of the surfaces

Vahid Torkzadeh, Saeed Toosizadeh • Measurement + Control (2019)

In this paper, an automated inspection system is proposed for detecting the location and measuring the size of existing dipping or buckling on the sandwich panel surface using an RGB camera and an inexpensive linear laser. The proposed meth...

DOAJ Open Access (DOAJ) DOI: 10.1177/0020294019847706

Correction of Postoperative Anemia in Patients undergoing Mitral Valve Replacement through Blood Saving Technology

B. M. Gumeniuk • Український журнал серцево-судинної хірургії (2020)

The aim. To investigate anemia of chronic disease (ACD) in patients with mitral valvular disease, to provide preoperative correction in these patients and to determine the level of postoperative anemia after mitral valve replacement (MVR) t...

DOAJ Open Access (DOAJ) DOI: 10.30702/ujcvs/20.4009/038055-060/5.16

Low-frequency noise analysis on asymmetric damage and self-recovery behaviors of ZnSnO thin-film transistors under hot carrier stress

Wonjun Shin, Ji Ye Lee, Jangsaeng Kim, Sang Yeol Lee et al. • Discover Nano (2024)

Abstract The need for understanding the low-frequency noise (LFN) of metal oxide semiconductor thin-film transistors (TFTs) is increasing owing to the substantial effects of LFN in various circuit applications. A focal point of inquiry pert...

DOAJ Open Access (DOAJ) DOI: 10.1186/s11671-024-04081-x

Forecasting Warping Deformation Using Multivariate Thermal Time Series and K-Nearest Neighbors in Fused Deposition Modeling

Donghwan Song, Adrian Matias Chung Baek, Jageon Koo, Moise Busogi et al. • Applied Sciences (2020)

Over the past decades, additive manufacturing has rapidly advanced due to its advantages in enabling diverse material usage and complex design production. Nevertheless, the technology has limitations in terms of quality, as printed products...

DOAJ Open Access (DOAJ) DOI: 10.3390/app10248951

PENINGKATAN KUALITAS DENGAN PENDEKATAN SIX SIGMA DAN PERPEKTIF MBNQA SEBAGAI KRITERIA PRASYARAT BAKU MUTU PADA PT. TAMANACO

Aditya Apriawan Saputra • J@ti Undip: Jurnal Teknik Industri (2025)

Penelitian ini dilatarbelakangi oleh tingginya angka cacat produksi aluminium collapsible tube khususnya pada produk Kloderma 0.05% gel 5 gram Ø13,4 x 90 mm di PT. Tamanaco. Pada semester kedua tahun 2023, tingkat defect mencapai 8,81% (1.2...

DOAJ Open Access (DOAJ) DOI: 10.14710/jati.20.2.42-68