Reset
Showing 20 of 534 academic articles

The influence of the volatiles on the slag composition for the heating process

Zhao Z.-Y., Zhao J.-X., Cui Y., Lu L. et al. • Journal of Mining and Metallurgy. Section B: Metallurgy (2020)

The physicochemical properties of slag are of great importance in pyrometallurgy. If there is a volatile component in the slag, evaporation will inevitably occur. As a result, the slag composition will change, and the measured results will ...

DOAJ Open Access (DOAJ) DOI: 10.2298/JMMB190509046Z

Evaluation of experimentally observed asymmetric distributions of hardness, strain and residual stress in cold drawn bars by FEM-simulation

Juliana Zottis, Carla Adriana Theis Soares Diehl, Alexandre da Silva Rocha • Journal of Materials Research and Technology (2018)

The purpose of this paper is to investigate the correlation of strain and hardness parameters in a drawing process chain of an SAE 1045 steel bar. The present work discusses the application of the experimental and numerical method of analys...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.jmrt.2018.01.004

A cluster randomised school-based lifestyle intervention programme for the prevention of childhood obesity and related early cardiovascular disease (JuvenTUM 3)

Haller Bernhard, Lammel Christoph, Hanssen Henner, Siegrist Monika et al. • BMC Public Health (2011)

Abstract Background Childhood obesity is not only associated with adult obesity but also with increased risk of adult onset of type 2 diabetes and subsequent coronary heart disease. The potential effects of school-based health intervention ...

DOAJ Open Access (DOAJ) DOI: 10.1186/1471-2458-11-258

Evaluating Load-Conditional Convergence in Lithium-Ion Battery Degradation: A Matched-Group Statistical Framework

Nnamdi C. Aronwora, Chibuzo Nwabufo Okwuosa, Jang-Wook Hur • IEEE Access (2026)

The rate of capacity fade in a lithium-ion battery following a transition to a new discharge current is widely assumed to equal that of a battery that has always operated at the destination current, an implicit premise referred to here as l...

DOAJ Open Access (DOAJ) DOI: 10.1109/ACCESS.2026.3732470

High Dimensional QSAR Study of Mild Steel Corrosion Inhibition in acidic medium by Furan Derivatives

Abdo M. Al-Fakih, Madzlan Aziz, Hassan H. Abdallah, Zakariya Y. Algamal et al. • International Journal of Electrochemical Science (2015)

The inhibition of mild steel corrosion in 1 M HCl by 17 furan derivatives was investigated experimentally using potentiodynamic polarization measurements. The furan derivatives inhibit the mild steel corrosion. The experimental inhibition e...

DOAJ Open Access (DOAJ) DOI: 10.1016/S1452-3981(23)06562-8

Filling the Gap of Meteorological Data Along the Prut River Valley, Romania - Cârja Experimental Weather Station (2013-2020)

Lucian SFÎCĂ, Pavel ICHIM, Constantin ION, Ștefan-Emanue BALTAG et al. • Aerul şi Apa: Componente ale Mediului (2021)

The study presents the results of the measurement realized at a meteorological weather station installed in Cârja village, situated in the valley of Prut river in the south-eastern tip of Vaslui county, Romania. The observations cover the i...

DOAJ Open Access (DOAJ) DOI: 10.24193/AWC2021_16

Biomass burning fuel consumption rates: a field measurement database

T. T. van Leeuwen, G. R. van der Werf, A. A. Hoffmann, R. G. Detmers et al. • Biogeosciences (2014)

Landscape fires show large variability in the amount of biomass or fuel consumed per unit area burned. Fuel consumption (FC) depends on the biomass available to burn and the fraction of the biomass that is actually combusted, and can be com...

DOAJ Open Access (DOAJ) DOI: 10.5194/bg-11-7305-2014

Green development efficiency and its determinants in China's agricultural product circulation Industry: An empirical analysis based on panel data from 26 provinces

Yuguo Jiang, Ziyu Zhao, Xinjie Zhao • Environmental and Sustainability Indicators (2025)

This paper employs the super-efficiency slack-based measure (SBM) model with undesirable outputs to measure the green development efficiency of the agricultural product circulation industry (APCI) across 26 provinces of China from 2013 to 2...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.indic.2025.100770

Approaches to Innovation Process Assessment: Complex Results from an Exploratory Investigation

Ondrej Zizlavsky • International Journal of Engineering Business Management (2015)

Managing innovation is vital for many enterprises to survive in a competitive and dynamic environment. Thus, decision-makers have always been involved in the challenge of finding the right performance measures for the innovation process. Th...

DOAJ Open Access (DOAJ) DOI: 10.5772/62052

The use of melting curves as a novel approach for validation of real-time PCR instruments

Helmut Von Keyserling, Thomas Bergmann, Moritz Wiesel, Andreas M. Kaufmann • BioTechniques (2011)

Validation of PCR thermal cycler performance is crucial in order to obtain reliable results. In this study, high resolu- tion melting curve (HRM) analysis is presented as a novel validation method for real-time PCR instruments. By ap- plyin...

DOAJ Open Access (DOAJ) DOI: 10.2144/000113735

Influence of Radar Parameters and Sea State on Wind Wave-Induced Velocity in C-Band ATI SAR Ocean Surface Currents

Rui Zhang, Jie Zhang, Xi Zhang, Chenghui Cao et al. • Remote Sensing (2022)

Wind wave-induced artifact surface velocity (WASV) is an important component of the sea surface motions detected by synthetic aperture radar (SAR) systems. Understanding the characteristics of the interference of WASV on SAR current velocit...

DOAJ Open Access (DOAJ) DOI: 10.3390/rs14174135

Online Classification of Road Roughness Conditions with Vehicle Unsprung Mass Acceleration by Sliding Time Window

Zhongxing Li, Wenhao Yu, Xiaoli Cui • Shock and Vibration (2018)

Suspension control systems are in need for more information of road roughness conditions to improve their performance under different roads. Existing methods of gauging road roughness are limited, and they usually involve visual inspections...

DOAJ Open Access (DOAJ) DOI: 10.1155/2018/5131434

PENINGKATAN KUALITAS DENGAN PENDEKATAN SIX SIGMA DAN PERPEKTIF MBNQA SEBAGAI KRITERIA PRASYARAT BAKU MUTU PADA PT. TAMANACO

Aditya Apriawan Saputra • J@ti Undip: Jurnal Teknik Industri (2025)

Penelitian ini dilatarbelakangi oleh tingginya angka cacat produksi aluminium collapsible tube khususnya pada produk Kloderma 0.05% gel 5 gram Ø13,4 x 90 mm di PT. Tamanaco. Pada semester kedua tahun 2023, tingkat defect mencapai 8,81% (1.2...

DOAJ Open Access (DOAJ) DOI: 10.14710/jati.20.2.42-68